MSDS Print E-mail
Section 1 : PRODUCT AND COMPANY IDENTIFICATION
Product name:
Battery Equaliser - Fluid
Manufacturer:

Battery Equaliser USA, LLC

1075 Linda Vista Dr, Suite D

San Marcos, Ca 92078

Manufuacturer emergency phone number:
888-851-4431
Section 2 : INGREDIENT INFORMATION
_____C.A.S._____
CONCENTRATIONINGREDIENT_NAME_____T.L.V.__________LD/50__________LC/50_____
10124-36-40.1-1CADIUM SULFATE0.002 MG(CD)/M3

280 MG/KG

RAT ORAL

47 MG/KG

MOUSE ORAL

NOT AVAILABLE
Section 2A : ADDITIONAL INGREDIENT INFORMATION
Note: CAS# 10124-36-4: ACGIH TLV TWA 0.01 MG(Cd)/M3 Inhalable dust.
Section 3 : HAZARD IDENTIFICATION
Emergency overview:
Battery Equiliser is a pink, odorless liquid. It contains a toxic substance and should not be taken internally. Be sure to apply with the same care as when normally adding water to any battery.
Route of entry:
Skin contact, eye contact and ingeston.
Effects of acute exposure
 
Eye contact:

May cause redness and pain.

May cause severe irritation.

Skin contact:

May cause dryness.

May cause mild irritation.

Inhalation:

No adverse effects expected.

Ingestion:

May cause vomiting.

May be toxic.

Effects of chronic exposure:
May lead to coma and death.
Sensitization to product:
Not available.
Carcinogenic effects:

Cadmium is a carcinogen.

Certain cobalt compounds are listed by IARC as carcinogens.

Reproductive effects:
Not available.
Teratogenicity:
Not available.
Mutagenicity:
Not available.
Synergistic materials:
Not available.
Section 4 : FIRST AID MEASURES
Skin contact:

Remove contaminated clothing.

Wash thoroughly with soap and water.

Seek medical attention if irritation persists.

Eye contact:

Flush with plenty of water.

Seek medical attention if irritation persist.

Inhalation:

No first aid should be needed.

If irritation occurs, consult a physician.

Ingestion:

Do not induce vomiting, seek medical attention.

Never give anything by mouth to an unconsious person.

Have victim drink ipecac syrup and approximately 300 ml of water.

Additional information:
The above information is believed to be correct but does not purport to be all inclusive and shall be used only as a guide. This company shall not be held liable for any inaccuracies.
Section 5 : FIRE FIGHTING MEASURES
Flammability:
Not flammable.
Conditions of falmmability:
Surrounding fire.
Extinguishing media:
Suitable for surrounding fire.
Special proceedures:
Self-contained breathing apparatus required. Firefighters sould wear the usual protective gear.
Auto-ignition temperature:
Not applicable.
Flash piont (°C), method:
Not applicable.
Lower flammability limit (% vol):
Not applicable.
Upper flammability limit (% vol):
Not applicable.
Explosion Data
 
Sensitivity to static discharge:
Not applicable.
Sensitivity to mechanical impact:
Not applicable.
Hazardous combustion products:
None known.
Rate of burning:
Not applicable.
Explosive power:
Not applicable.
Section 6 : ACCIDENTAL RELEASE MEASURES
Leak/Spill:

Wear appropriate protective equipment.

Place in an approved container and seal.

Mop up or soak up with absorbent material.

Section 7 : HANDLING AND STORAGE
Handling procedures and equipment:

Use adequate ventilation.

Handle with care.

Wash clothing before re-use.

Wash thoroughly after handling.

Wear personal material safety protection.

Avoid contact with skin, eyes and clothing.

Do not ingest.

Storage requirements:

Store in a clean, dry place.

Avoid direct sunlight during prolonged storage.

Section 8 : EXPOSURE CONTROLS / PERSONAL PROTECTION
Precautionary Measures
 
Gloves/Type:

Image

Rubber Gloves

Repiratory/Type:
None required under normal use.
Eye/Type:

Image

Chemical safety goggles.

Footwear/Type:

Image

Safety shoes per local regulations.

Clothing/Type:
Normal work clothes.
Other/Type:

Eye wash facility should be in close proximity.

Emergency shower should be in close proximity.

Ventilation requirements:
Adequate general ventilation.
Exposure limit of material:
Not available for mixture, see the ingredients section.
Section 9 : PHYSICAL AND CHEMICAL PROPERTIES
Physical state:
Liquid.
Appearance & odor:

Odorless.

Pink

Odor threshhold (ppm):
Not available.
Vapor density (mmHg):
Not available.
Vapor density (air=1):
Not available.
Volatiles (%)
 
By volume:
Liquid.
Evaporation rate (butyl acetate = 1):
Not applicable.
Boiling point (°C):
115°C
Freezing point (°C):
Not applicable.
pH:
9.22
Specific gravity @ 20 °C:
Not available.
Solubility in water (%):
Very soluble.
Coefficient of water/oil dist.:
Not available.
VOC:
Nil
Section 10 : STABILITY AND REACTIVITY
Chemical stability:
Stable under normal conditions.
Conditions of instability:
Heat and open flames.
Hazardous polymerization:
Not expected to occur.
Incompatible substances:
None known.
Hazardous Decomposition products:
None known.
Section 11 : TOXICOLOGICAL INFORMATION
LD50 of product, species & route :
Not available for mixture, see the ingredients section.
LC50 of product, species & route :
Not available for mixture, see the ingredients section.
Section 12 : ECOLOGICAL INFORMATION
Evironmental toxicity:
No data at this time.
Section 13 : DISPOSAL CONSIDERATIONS
Waste Disposal:
In accordance with minicipal, provincial and federal regulations.
Section 14 : TRANSPORTATION INFORMATION
TGD classification:

Image

Not regulated.

Special shipping information:
See transportation information.
Section 15 : REGULATORY INFORMATION
WHMIS classification:

Image

D2A

DSL status:

The substance(s) listed in section 2 appear on the Domestic Substances List.

TSCA inventory:
All components of this product are listed on the TSCA inventory.
SARA Section 313:
Copper sulfate < 1%.
CERCLA reportable quantity:

Aluminum sulfate - 5000 lbs.

Cupric sulfate (7758-98-7) - 10 lbs.
Section 16 : OTHER INFORMATION
Supplier MSDS date:
2007/09/04
Next >
[ Back ]